Identifying Ford 9 Inch

No view

This Tech Tip is From the Full Book, FORD DIFFERENTIALS: HOW TO REBUILD THE 8. INCH. The Ford 8.8-inch axle has a cast center section and the internal components are installed from the rear. There is a very fundamental difference between Ford's 8.8- and 9-inch axles..The most popular rear end around is no doubt the Ford 9 inch unit, it is used by restorers, street rodders and racers alike, regardless of whatnd of car the axle is going in. Many custom made axle housings for the GM boys utilize the 9 inch Ford, even though they to admit it. Ford used the axle from around the 1957 .The most popular rear end around is no doubt the Ford 9 inch unit, it is used by restorers, street rodders and racers alike, regardless of whatnd of car the axle is going in. Many custom . Rear axle tags if present on your housing can aid in identifying what is behind your center for gears,splines etc.Ford has changed the .Differential Identification by Tag Number. The most accurate differential identification is provided by the bottom line of the tag number or axle stamp. Differential tags can easily be used to identify Dana and Ford differentials..

NEW UPDATE 12/20/04 !!! Introduction . The most popular rear end around is no doubt the Ford 9 inch unit, it is used by restorers, street rodders and racers alike, regardless of whatnd of car the axle is going in.. Can anyone tell me how much gear oil I should put in my Ford 9 inch rear end? It was built by Currie a long time ago and I am doing a frame off. Next challengethe rear end. I've got a Ford 9-inch rear 28 spline, not that it matters that I want to convert to the Chevy 4.75 bolt pattern. I.In the quest for better elapsed times from our S-10 race truck, we decided to swap the 4.33 ratio ring and pinion in the truck's 9-inch Ford axle for a set of 4.56 gears..

No related post!